Infrared Motion Sensor
Infrared Motion Sensor usually use pyroelectric components, which will lose the charge balance when the temperature of infrared radiation from the human body changes and release the charge outward. The subsequent circuit can generate alarm signals after detection and processing. The human body has a constant temperature, generally at 37 degrees, so it will emit a specific wavelength of about 10UM infrared ray, passive infrared probe is to detect the human body emitted about 10UM infrared ray and work. The infrared ray emitted by the human body about 10UM is enhanced by the Ferrier filter and then concentrated on the infrared induction source.
Infrared Motion Sensor does not emit any type of radiation, the device power consumption is very small, good concealment.
Infrared Motion Sensor are widely applied to the fields such as electronic anti-theft alarm, human detection. They win great popularity among customers and specialists for their low price and stable technical performance.
Two Wire Infrared Sensor
PDLUX PD-PIR123
Read More›
Two Wire Infrared Sensor can be used to control incandescent lamps. The product is also a manual switch, when you need conference rooms or other places when a slide or film programs can use this switch to turn off the lights. This product should be installed in a standard wall box to replace a single pole switch. This product requires grounding.
Remote Infrared Sensor
PDLUX PD-MV1008
Read More›
Remote Infrared Sensor is a motion sensor whose detection range is 360° and it adopts the microwave sensor(working frequency is 5.8G Hz ,transmission power:<0.2mW) together with the PIR sensor, four working state can be choosed by preessing the button which is more stable and safer performance . It can be used where the ambient temperature is about -10℃~40℃.
Embedded Infrared Sensor
PDLUX PD-PIRM20
Read More›
Embedded Infrared Sensor gathers automatism, convenient safe, saving-energy and practical functions. One detector inside compose a wide range detection field, it utilizes the infrared energy from human as control-signal source, it can start the load at once when one enters detection field. It can identify day and night automatically. It is easy to install and used widely.
Ceiling Infrared Sensor
PDLUX PD-PIR101-Z
Read More›
It is a medium and high-end product. Although the cost is increased compared with the conventional version, the reliability and life of the product are greatly increased. Ceiling Infrared Sensor is equal to choosing peace of mind, and choosing safety.
Wall Infrared Sensor
PDLUX PD-PIR125-Z
Read More›
Wall Infrared Sensor is an advanced digitally controlled infrared pyroelectric intelligent sensor product. Wall Infrared Sensor uses one high-resolution sensor that is almost twice the sensitivity of a single traditional sensor. lt uses the MCU to accurately calculate the switch information, and accurately controls the relay to be turned on at the zero point of the sine wave, so that each load is turned on.
360° Detection Infrared Sensor
PDLUX PD-30N2
Read More›
360° Detection Infrared Sensor uses a digital information processing system. The easiest way to consider the 30N2 at the start of the design is to remove the front frame of the sensor and select the appropriate location for each function to be replaced.
High-power Infrared Sensor
PDLUX PD-PIR118
Read More›
High-power Infrared Sensor can identify day and night automatically. And the working light can be chosen freely and make it work at night and not work in the day time.
Zero Crossing Technology Infrared Sensor
PDLUX PD-PIR-M15Z-B
Read More›
Zero Crossing Technology Infrared Sensor can be used with any product, or it can be installed and used independently. There are two installation methods: wall and ceiling. Eg, add the sensor, from one normal lighting to automatic sensor lamp.
